Sound deadening suitable for Mustang, Charger, Camaro etc 

The Muscle Car Floor pan kit includes:

Covers carpeted areas
SKU: MSC_1  (approx 15kg)
2 Boxes (3.6sq/m) of Stage 1 Sound Deadener -  Install on your floor, firewall, cover everywhere your carpet goes
2 Boxes (3.4sq/m) of Stage 2 Acoustic Liner - peel and stick modern day carpet underlay. Ready for carpet to go over top.
1 x Install kit - Application Roller, Utility Knife and Aluminium Foil Tape
Bonus Stubby Holder and bottle open (only to be used after the job is done)

The Muscle Car Floor + Rear 1/4's kit includes:
Covers carpeted areas and rear wheel arches including diff section
SKU: MSC_2 (approx 20kg)
3 Boxes (5.4sq/m) of Stage 1 Sound Deadener -  Install on your floor, firewall, cover everywhere your carpet goes
2 Boxes (3.4sq/m) of Stage 2 Acoustic Liner - peel and stick modern day carpet underlay. Ready for carpet to go over top.
1 x Install kit - Application Roller, Utility Knife and Aluminium Foil Tape
Bonus Stubby Holder and bottle open (only to be used after the job is done)

The Muscle Car Complete Interior Kit:
Insulate complete car ready for trim.

SKU: MSC_3  (approx 40kg)
4 Boxes (7.2sq/m) of Stage 1 Sound Deadener -  Install on your floor, firewall, cover everywhere your carpet goes, rear arches and outer door skins
2 Boxes (3.4sq/m) of Stage 2 Acoustic Liner - peel and stick modern day carpet underlay. Ready for carpet to go over top.
2 Sheets (3sq/m) of Mass Noise Liner - Firewall blanket to be installed on interior side from plenum to floor, reduces heat and sound entering. Drop in 2 in 1 sound control blanket for boot area, removable and allows for spare wheel access. Place floor carpet/vinyl directly over top no need for Stage 1 deadener in this area.
4dr Door Restore kit - Factory waterproof membrane to seal off door cards, use on front & rear doors or 1/4s
2 Sheets (2sq/m) of Insul-Layer foam - peel and stick 6mm closed cell foam for roof skin, stops heat and sound, cover entire roof skin as a stage 2 product.
1 x Install kit
- Application Roller, Utility Knife and Aluminium Foil Tape
Bonus Stubby Holder and bottle open (only to be used after the job is done)

 

Floor + Rear 1/4's kit shown below (MSC_2)

 

 

Shipping Weight 49.9995kg
Shipping Width 20.000m
Shipping Height 10.000m
Shipping Length 27.000m
Shipping Cubic 0.029525999m3

Be The First To Review This Product!

Help other T & J Restorations - Authorised Car Builders Distributer USA users shop smarter by writing reviews for products you have purchased.

Write a product review